Return to the Basements Forum | Post a Follow-Up

 o
Need Help...Asbestos Flooring in Basement

Posted by pwalsh87 (My Page) on
Sun, Jun 2, 13 at 22:49

Hello All,

I need some help on determining a good sealant for the asbestos flooring in my basement. I just bought my house this past October and have finally had some time and money to redo the flooring in my basement. I have about 890 sq ft to work with and just bought some Acquarius Waterproof Vinyl Plank flooring to do the job.

I'm worried because I have the typical 9 x 9 inch tile in the basement which I am led to believe is made of asbestos. About 98% of the total tile amount is still very well adhered to the floor. Yet there are a few tiles, here and there, which are chipped on the edges. Also about two tiles are starting to come up. I'm assuming the chipping in coming from age of material and general wear and tear of the previous owners. Now I know that breaking up these tiles is deadly so i do not want to touch them and because they are in relatively good condition i'd like to seal them and move on with my flooring.

I have read a lot but have been getting a general impression of confusion among a lot of people. My question is what type of sealant should I use for my floor? The floor is very level throughout the entire room and has a gradual grade to the drains in the basement. I've read a lot about self leveling compound, specifically Tru self and level quik. My floors are already level so wouldn't this compound just sit there with me needing to spread it? I've also read that self leveling compounds need a very clean, degreased floor for usage and generally crumble when the subfloor below bellows. Now as for epoxy's I've seen kits that can work but they run extremely expensive. I've also seen that epoxy's require that you remove wax and on top of that 'beat up' the floor which would require possibly breaking the tiles which is bad.

Also I've run into coatings for garage/shop floors, floor wax, cement based floor patches, embossing leveler compounds, vinyl flooring sealants, etc. So to say the least there have been a lot of suggestions.

All in all i'm not sure what to use. I'd like to safely cover the asbestos tile and protect it from future usage. Is there anyone out there who has successfully bonded any of these substrates to VAT? Any help would be greatly appreciated. Thanks


Follow-Up Postings:

 o
RE: Need Help...Asbestos Flooring in Basement

I haven't found any type of sealant or paint that I would consider durable enough. I would cover the floor with new tile or vinal sheeting without removing the existing tile. Leveling compound can be used first to fill gaps left by chipped, loose or missing tiles.


 o
RE: Need Help...Asbestos Flooring in Basement

Asbestos floor tile is not generally brittle to a large degree and asbestos is only dangerous if you inhale it into lungs.

I would just get a n95 dust mask pick up the lose tiles and burying them in the yard as it is a mineral and not subject to enviornmental problems and quite often buried in landfills around here.

Since its a basement I assume it is a concrete floor underneath and the adhesive is holding the tile firmly in place go ahead puts some floor patch down to cover the area tiles are missing I am not familar with the flooring you are putting down but most plank flooring I am familar with do not use adhesive or fasteners check your manufactures recomendation.

Good Luck

Eddie


 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!


Return to the Basements Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Please review our Rules of Play before posting.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.


Learn more about in-text links on this page here