There's also

http://www.vacuumcleanerinfo.com/
http://www.oveninfo.com/
http://www.dishwashersinfo.com/
http://www.espressomakerinfo.com/
http://www.coffeebrewerinfo.com/
http://www.grillsinfo.com/
http://www.washerdryerinfo.com/

Always nice to read and another good source to compare appliances.

1. Is there a 30" Gas Range available with rear burners that can fit large pots?

2. The NXR 30" gas range has equally spaced burners but has received some reviews saying the metal is thin. Does anyone know how the NXR customer service is?

3. GE Cafe has many reviews complaining about a very loud fan noise even with traditional oven use. The loud fan noise is described to continue for a substancial amount of time after cooking and after the the oven off. After speaking with a GE representative, he advised that since the electronics are in the front, the fan needs to keep them from over heating. Does this apply to other brands with the electronics in the front?

4. Does anyone know of a 30" gas range with the electronics in the front with a quieter fan?

5. Is there a range with electronics on the top that allows room for larger pots?

When measuring from the middle of the back burner to the back of the range top horizontally, both the LG 30" gas range (model LGLRG3097[ST]) and the GE 30" gas (model CGS985SETSG) range have a distance of 4 and 5/8 inches (about 5 inches).

6. Is there a 30" gas range with electronics in the back (on top) with slightly more distance between the center of the back burner and back of range top?
If we could find a range with 5.5 inches, it could accomodate a 11 inch pot and a space of 6 inches would accomodate a 12 inch pot . One would think that most prefer to have the larger pots in the back, to make cooking easier and especially with young children in the house.

7. How does LG customer service compare to GE customer service, compared to NXR customer service? Is it possible to get parts from these three companies without a hassle?

Please advise.

Thanks for reading!!

The CP 171 was on my short list. Now I will have to begin again. Personally, I think of the dual compressors as a plus. It didn't seem the reviewer shared that opinion. I have seen the Blomberg's in person and agree that compared to the Leibherr they do seem like the poorer country cousin, so to speak. But the Leib is not in the budget. I also prefer white over stainless.

Sigh.....

There is a post or 2 about problems getting NXR parts.
But---- As I recall, that poster was able to find a part, (rather than the "Genuine NXR Part" and it worked just fine.

Just do a search, at the BOTTOM of the main appliance page
(Hint hit your browser back arrow) and search for NXR.

They are simple machines as Nunya has said, and not a lot to break, and things like ignitors, ignitor modules are easily found with out "NXR's help---that so far, I haven't found any "Glowing Reports About" (Duro Corp), I think.

Good luck on your pending decisions!

Gary