|
Sat, Feb 2, 13 at 5:28
| I purchased a Whirlpool refrig. They changed the door from Rt. to Lt. before installing it. They showed me an indentation in the door where the screw used to be. Apparently, when they tighten them at the factory it's not done by a human who would know not to tighten the screw so that it would leave a dent impression. The machine that does the job doesn't know that-- therefore a dent. I told them to take it back and I'd have to think about my purchase. Has anyone else had a similar problem with changing their door from Rt. to Lt. and it leaving a dented door? Would I be looking at the same problem with any SS refrig? I appreciate your thoughts. |
Follow-Up Postings:
Post a Follow-UpPlease Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Appliances Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.