A CAT pump/Honda from Northern is usually a good bet. Not real familiar with what they are offering, but at 2500 psi and 3.5 gallon unit will work well. Higher flow is usually more useful than higher pressure as the pressure can wreck things, but higher flow almost always cleans better. Be very careful with inlet filters as they can easily restrict enough to cavitate and destry the pump. They also don't soften water, only take out particles, unless you get special filters that are very expensive. Moderately hard water is usually not much of an issue.

Irish Brewer Thank you very much. Think I'll leave it alone for a while. Cheers

Drastic mold removal from HE3 I finally got rid of the mold and the smell! No amount of cleaning of the machine would have solved my problem. I checked the entire machine and could not find the source. So I decided to rip the machine apart! To see pictures of the inside of the machine go to the following link: http://www2.tdux.com:8090/images/personal/2006/Washer/ You might have to cut and paste this to you browser. The mold was inside at the top of the front and back of the machine and caked behind the drum. As of now the machine works good as new believe it or not! The odor is gone and the clothes are clean once more! If they had used stainless steel behind the drum most of the mold and debris would never have collected and if they had of added a few carefully placed cleaning jets and a special cleaning cycle then this problem would never have happened! I took a big chance tearing the machine apart. I do not encourage anyone to take this drastic measure but I figured I had nothing to loose! I could not keep using the machine the mold and smell was making my family sick! NOTE: I would only use the special detergent they suggest!! The picture of the back side of the drum shows about 1/2 inch layer of mold/detergent and dirt. This would have been drastically reduced if we had started out using the correct detergent! NOTE: Always remove clothes as soon as wash is complete! leave door open and open soap tray! This will help to dry the machine! NOTE: The mold would have never happend though if they had of designed the machine correctly!!! Any comments? Email duck@tdux.com Here is a link that might be useful: Mold

One of your water valves (hot or cold, probably not both) is not fully sealing-off and is seeping water in. Run a spin-only cycle to drain the accumulated water, and turn the supply faucet(s) off, the problem should stop. That'll confirm what is wrong. Call for service. Until service arrives, leave the faucets off when not using the machine. Of course you'll have to turn them back on if you need to wash.