Pull placement

skind49November 10, 2013

I want to use this type of squared upper for my cabinets in my corners. My cabinet maker thinks the best way to keep the opposing door pull from hitting each other upon opening is to only use one pull. The other would be opened with a grab to the inside. That would seem weird visually. The only other way, he said, is to put the pulls about 3-4 inches in from the edge. If you have this set up, can you tell me how to do this so I can use two pulls properly? There's got to be a way to do this. I just can't figure out how. Thanks for the help.

Thank you for reporting this comment. Undo
blackchamois

I was going to do this type of corner cab, and my cabinet maker would have done it as yours is suggesting with a knob on only one door and the other door opened by grabbing the inside. (And if you have seen the other pics of the cabinet you posted, they have done the same.) See the link below.

Good luck!

Here is a link that might be useful: See the post from athomeinva

    Bookmark   November 10, 2013 at 10:27PM
Thank you for reporting this comment. Undo
skind49

Thank you, BlackChamois. I had not seen the other photos and it was helpful to read the other posts. Sorry it took me a bit to get back to you.

    Bookmark   November 15, 2013 at 7:19PM
Thank you for reporting this comment. Undo
blackchamois

Keep us posted on what you decide to do!

    Bookmark   November 15, 2013 at 8:37PM
Sign Up to comment
More Discussions
Any reason a DW couldn't go next to a fridge?
We need to pull the trigger on our cabinets next week,...
gretchen718
Ikea Cabinets & Butcherblock - Quality?
We're about 95% sure we're replacing our cabinets....
annaw_123
OT - Any Walking Dead Fans..?
Very much looking forward to tonight's episode..:)
oldbat2be
Strategies for washing dishes in a large single sink vs double sink
Hi all, We have in our plans to get a large (33 inch)...
ontariomom
Banquette as only dining area?
I apologize for starting a banquette thread again but...
vdinli
Sponsored Products
T807 Trac-Master Slant Mesh Low Voltage MR16 Lamp Holder
Lightology
NW 3528 Single Row LED Strip Light 240/m 10mm wide 5m Reel
EnvironmentalLights.com
Lynx 42-inch Built-in Grill with ProSear
FRONTGATE
Richland Ceiling Fan by Kichler
$168.30 | Lumens
Circus Time Giclee Glow Tiger Bronze Club Table Lamp
$99.99 | Lamps Plus
Spear Shaped Pull with Smooth Iron Construction
Signature Hardware
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™