Mounting block & plate on Cedar Shake Shingles?

pbx2_gwNovember 19, 2013

My electrician put on some dusk to dawn light fixtures yesterday on the shingles part of the exterior wall of on our garage.

He used a something like the link below which made the light protrude (due to the box behind the plate & not flush against the Hardiplank cement shake shingles.

Are there any other solutions to make it flush against the shingle siding?

Here is a link that might be useful: Undesired mounting plate & block

Thank you for reporting this comment. Undo
Ron Natalie

You have two options: get a mounting plate that conforms to the siding OR cut the siding around the mourning plate.

    Bookmark   November 19, 2013 at 10:46AM
Sign Up to comment
More Discussions
Swimming pool wiring
I have 2 gfci circuits operating two pool pumps. Is...
dalemd88
Installing 220/240V. 50/60Hz appliances from Europe
I hope to install a "Domino" modular system...
panchoandlefty
Please Critique Low-Volt (Home Automation) Plan/Proposal
GW/Houzz Community, As always, I want to thank this...
Andrew K.
Light/Switch wiring
Here is the scenario. Have a kitchen light that needs...
wgl3333
Bath fan/light combo
Attached is wiring diagram of masterbath (I hope I...
jaspol
Sponsored Products
Lenox Colonial Tradewind Saucer - Set of 2 - LNOX1646
$33.90 | Hayneedle
Progress Lighting T-Bar Mounting Clips for Recessed Lighting P8773-01
$6.03 | Home Depot
Black One-Light Outdoor Wall Mount with Clear Glass
$32.85 | Bellacor
Houzer Premiere Gourmet Triple Bowl
Overstock.com
Delilah Wall-Mount Faucet - Lever Handles
Signature Hardware
Modern Block Rug 8' x 11' - ASHWOOD/LIQUORICE
$1,399.00 | Horchow
European Purple Tin Plate Decor
| Dot & Bo
Misfit Shine Activity Tracker
$99.95 | FRONTGATE
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™