T8 ballast-socket wire

ionized_gwOctober 21, 2013

Should wire marked. "THWN THHN 600V gasoline/oil resistant", be used to connect ballasts to T8 sockets within the luminaires?

Thank you for reporting this comment. Undo
bus_driver

Are those conductors suitable to be used inside the fixture for the power supply?

    Bookmark   October 21, 2013 at 9:34PM
Thank you for reporting this comment. Undo
ionized_gw

Yes, that is the question. My understanding that the strip fixtures are considered to be enclosures equal to junction boxes and conduit. If this is not the case, in this context, please correct me. That leads me to beleive that any wire that can be used in conduit or junction boxes would be a correct conductor to be used within the strips.

    Bookmark   October 22, 2013 at 12:21AM
Sign Up to comment
More Discussions
Well this sucks
Just when you thought the idiot popup ads in the gardenweb...
Ron Natalie
Light boxes on/in 6X8 timber floor joists for log home
Just trying to figure how to wire a couple light fixtures/chandelier...
yota_85
Insulation in electrical box
While in my attic the other day I saw an open electrical...
sgilliatt
ARGH! no boxes
Went over to my daughter's house to help them change...
Ron Natalie
Need help Replacing old dimmer that used only 2 wires in a three way
I need advice as to which wire to connect to which...
txmat
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™