Code question

stash-hdyAugust 20, 2010

Have removed a Whirlpool tub and won't replace it. The questions I have concern the wiring for the pump which now will not be used for its intended purpose, the pump on the tub.

The wiring for the pump, to disable the wire do I need to cut the wire and push it out of the box or put wire nuts on the wires and leave in the box?

Are there any height requirements for a plug in the bath area, I can also install a plug on the same wire where it attached to the pump. This plug will be GFI protected.

Thank you for reporting this comment. Undo
stash-hdy

Found my answer, thanks anyway

    Bookmark   August 21, 2010 at 7:53AM
Sign Up to comment
More Discussions
Replacing fan speed dial back to standard toggle?
I am removing a ceiling fan and replacing it with a...
onkyokoi
Looking for Ideas For Lighting at base of 300' long driveway
Sorry for the "picture through the screen"...
dixieman
Insulation in electrical box
While in my attic the other day I saw an open electrical...
sgilliatt
Reuse electrical panel
I replaced a 24 circuit Square D panel with a new 40...
zver11
Replacing dimmer switch: different wire colors on new switch
My DR lights, which are controlled from two switches,...
msa6
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™