No power to fuse socket

sbhcomJuly 18, 2010

I have an old fuse box with edison fuses and pull out blocks, one of the fuse sockets have no power going to it, I used a muti-meter to check it and it is dead... I checked the pull out block fuses right above it and they fine...any suggestions?

Thank you for reporting this comment. Undo
bus_driver

Edison-base fuses have incoming power to the center contact in the bottom of the screw shell. Often that contact is a screw that also holds the screw shell in place by means of an insulating washer. That screw must be snug. The screw shell receives power only when a good fuse is installed.

    Bookmark   July 19, 2010 at 7:23AM
Thank you for reporting this comment. Undo
sbhcom

I did not notice any loose screws, I did loosen and then re-tighten the screw shell to make sure there was contact. I will recheck all the screws one more time....any others??

    Bookmark   July 19, 2010 at 10:16AM
Sign Up to comment
More Discussions
Re-wiring range to service spa
what connectors are appropriate for joining 6-3 NMB...
justsomeotherdude
Please Critique Low-Volt (Home Automation) Plan/Proposal
GW/Houzz Community, As always, I want to thank this...
Andrew K.
Well this sucks
Just when you thought the idiot popup ads in the gardenweb...
Ron Natalie
Spa Capacitor question
My spa is wired for 220v. The pump motor is rated for...
pugmark
Electrical arc on television cable wire in basement
I am getting and electrical arc (sparking) on my t.v....
Bethany55
© 2015 Houzz Inc. Houzz® The new way to design your home™