Underground connection.

inganeerJuly 9, 2011

My neighbor ran over my exterior yard light breaking the direct buried 2-12 AWG conductor. I can excavate in the area of the broken end of the conductor, but to excavate and replace the entire conductor would be almost impossible because of a large tree and sidewalk. How do I go about connecting a new conductor to the old underground?

Thank you for reporting this comment. Undo
Ron Natalie

3M and others make UF splice kits. Not the most optimal solution but it will work.

    Bookmark   July 9, 2011 at 4:26PM
Thank you for reporting this comment. Undo
countryboymo

I would keep a mental note where the splice is so if there are future problems you might remember where the splice is.

    Bookmark   July 13, 2011 at 9:43PM
Sign Up to comment
More Discussions
Please Critique Low-Volt (Home Automation) Plan/Proposal
GW/Houzz Community, As always, I want to thank this...
Andrew K.
Too much load for circuit?
I have 200 amp service to the main panel (which has...
zver11
Looking for Ideas For Lighting at base of 300' long driveway
Sorry for the "picture through the screen"...
dixieman
new wiring project
I have a water damaged room I will soon be renovating....
CharlesInVT
Motion sensor that doesn't click
I have a motion sensor very much like the picture attached...
drmeow3
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™