Shopcraft Table Saw T-6700

prondouAugust 21, 2010

Hi All, Wanted to find out where I can get a manual, and parts for a Shopcraft Table saw. It's a 2 hp. Got it for $10 and hope to make it usable. It runs, but is missing the guard and rip fence. Also, the angle adjusting shaft is missing the bolt that goes to the saw carriage. It runs, but the blade appears to rotate as if on a clutch. Any ifo helpful. Is this brand made by someone else, or is the same as another name brand? I know it's a cheaper saw, but I would only use occaisionally.

Thank you for reporting this comment. Undo
HandyMac

I tried to do some research on that saw with little success.

It was made under that name by at least two different companies, both of which are no longer in existance.

What that means is that even iff you could find the manual, it would take buying another saw to get any parts.

There are all kinds of comparable saws on Craigs List or other places for $40-$70 which have all the parts and even blades.

You will be money and time ahead to buy one of those.

    Bookmark   August 22, 2010 at 2:02PM
Sign Up to comment
More Discussions
are these cabinets discolored from cigarettes?
Not sure if this was a refacing gone bad, or nicotine...
cindywhitall
Planing weathered/near rotted lumber?
I was just curious if it's OK to run some old, very...
fireweed22
Refinishing bedroom furniture
Hi everyone! Need advise please. We refinished a computer...
glittergirl_tx
Brand new dewalt planer, not feeding?
Hopefully it's just me doing something wrong. It's...
fireweed22
Maple floor, pine trim oak cabinets
Help please! We just sanded our maple floors and are...
JenG92
© 2015 Houzz Inc. Houzz® The new way to design your home™