Any benefit shooting pinners in Miters

chefwongJuly 18, 2012

Wonky not so flat basement flooring.

Some outside miters were fairly tights,

Others no so.

I plan to caulk the minor gaps (with excess) and gut the excess to create a sharp line on the small gaps. Any benefits on shooting a couple of pinners in it. I've done pinners/glu on crown but the crown has always been tight to each other

Thank you for reporting this comment. Undo
sombreuil_mongrel

Outside miters in flooring makes no sense. I take it, then, that maybe you mean baseboard?
18 ga. brads are more likely to have an effect than 21 or 23 ga. pins.
Casey

    Bookmark   July 19, 2012 at 6:43PM
Thank you for reporting this comment. Undo
homebound

So the outside miters don't meet up because the floor is not level? I would recut the miters (maybe on a slight angle, too) to get them to meet more tightly. Little bit of trial and error. Glue and nail, then caulk the wall gaps.

    Bookmark   July 20, 2012 at 8:38AM
Sign Up to comment
More Discussions
Differences in Wood Stains?
I went to purchase some stain to refinish a stripped...
jellytoast
making templates from graph paper
I seen some of the woodworking plans on the Internet...
hoganjr
What sealer for reclaimed redwood deck?
We have old growth redwood from a water tank that DH...
Honu3421
Wood surface with bad smell
I purchased used entertainment shelf from Kijiji and...
markintosh
Refinishing bedroom furniture
Hi everyone! Need advise please. We refinished a computer...
glittergirl_tx
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™