Craftsman GDO repair

Dennis69December 26, 2012

I have just replaced the gears on my Craftsman GDO which were stripped. The repair inst. say to run the opener untill the sprocket completes a clockwise cycle. When the limit switch reaches the down or up contact the motor does not stop or reverse but contunues to run. Could it be a logic board problem? Does the door have to be connected?

Thank you for reporting this comment. Undo

no the door does not need to be connected. Did you make sure the RPM sensor (the rotating plastic bladed piece) is fully seated so the fins go through the sensor?

    Bookmark   January 1, 2013 at 10:49AM
Sign Up to comment
More Discussions
home ventilation system (EZ Breathe)
Hello! Has anyone out there had the EZ Breathe Ventilation...
adjusting stop on lazy susan
Hi all, I have recently moved into an older home with...
Sidewalk crack
Any way to fill/hide this crack? I could cut slot wider....
Where to purchase Spanish roof tiles? I just need 2 pieces.
One handyman came to my house to evaluate the price...
How to safely pull down attic stairs in 12' ceiling
Hello all, I am buying a house with 12' ceilings and...
Sponsored Products
Hinkley Manhattan 11 3/4" High Bronze Outdoor Wall Light
Lamps Plus
Afina Vanderbilt Medium Triple Door Recessed Baroque Medicine Cabinet - 42W x 34
Natural Inspirations Multi-Light Pendant by Fine Art Lamps
$1,039.50 | Lumens
Corner Window Black 16 Inch Outdoor Hanging Pendant
$150.00 | Bellacor
Koncept Gen 3 Equo Warm Light LED Floor Lamp Orange
Euro Style Lighting
10 Inch Wide Round Bulkhead In Rust
$37.81 | Bellacor
Indoor Ceiling Fans and Light: Hampton Bay Lazerro II 52 in. Oil Rubbed Bronze C
Home Depot
Cerno Forma Black Walnut LED Floor Lamp with Linen Shade
Lamps Plus
© 2015 Houzz Inc. Houzz® The new way to design your home™