Another garage door opener problem.

pwpapineauDecember 11, 2008

I'm having difficulty finding my problem in the previous posts because they discuss so many different types of problems. Here's mine.

I have a Craftsman garage door opener 3/4 hp.

All remotes stopped working at the same time, but the wired manual wall switch works fine. The safety sensors show a green light and an orange light. If I obstruct the sensors, the green light goes out and the door will not close with the wall switch.

The proper lights go on an off in sequence when programing the either remote. When I press the remote, the programing light (on the card) blinks weakly for as long as I hold down the button.

I replaced the controller card, but have the same symptoms.

I'm clueless.

Any ideas.

Thank you for reporting this comment. Undo
don_1_2006

I sent you an e-mail.

    Bookmark   December 11, 2008 at 4:35PM
Sign Up to comment
More Discussions
What type of wall is this and how do I fix it?
The bottom part of my closet interior wall is crumbling,...
sippy_spence
Jacking house up
Ok the first time I posted in wrong place. I'm going...
music9704
Insulating an inaccessible crawl space?
My 1940s bungalow style house sits on a crawl space...
blessedbe
2x8 Joists are 1.75x7.75 and 2x6 Joists are 1.75x5.75? why is this?
I know that lumber is smaller than actually stated...
tlbean2004
Painting exterior of house with cedar siding---what to expect
I am about to start getting estimates on having the...
sierrashopper
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™