need help with Morse 60 DeLuxe Precision

barrierislandJune 17, 2008

I bought this at an estate sale because it looked old and familiar, like what I learned on. Has been cleaned, oiled, new belt/bobbin ring. Runs smooth and quiet - but the needle thread does not pick up the bobbin thread. Also, what setting for the dial for tension? Set stitch length to 12 and ran out of memories!

Thank you for reporting this comment. Undo
damascusannie

Be sure you have the needle set correctly. I THINK the flat side of the shank is supposed to face to the right on these. You'll have to figure out the tension setting for yourself. If it's pulling the bobbin thread to the surface, loosen the top tension. I like to tighten down the tension until this happens, then very slowly back it off just until I can't see the bobbin thread any more.

Annie

    Bookmark   June 24, 2008 at 9:56AM
Sign Up to comment
More Discussions
Cost estimate to shorten two curtains
Anyone have an idea how much it would cost to have...
vithdude
Can you tell me if this will work?
Since I have been socked in for four days now, have...
barb_roselover_in
questions about sewing lipped cord onto draperies
I am sewing drapery panels that will have a 2 foot...
lsst
Keeping the tredal cabinet, swapping the machine (does not fit)
We have an Eldredge treadle machine and it's rusty...
archangel2003
fabric for a pant suit
I have been wanting to make a periwinkle pant suit...
jewels247
© 2015 Houzz Inc. Houzz® The new way to design your home™