Installing a kitchen sink - no mounting clips

jgarzasrOctober 14, 2010

I am installing a wet bar in my basement - so I picked up a small - pretty nice used sink from habitat for humanity restore. However the mounting clips that were welded on the sides of it - are broke off. Any ideas of another way to pull this sink in tight on the counter to seal the edges? with out having any mounting clips? Thanks!

Thank you for reporting this comment. Undo
randy427

I've used silicon adhesive caulk when access to the clips was blocked. Put a bead of caulk around the edge of the counter opening, set the sink and put 10 to 20 pounds of weight in the sink until the caulk has time to cure. Clean up any 'squeeze-out' while it's still wet.

    Bookmark   October 14, 2010 at 12:16PM
Thank you for reporting this comment. Undo
macv

Polyurethane adhesive sealant would adhere better especially where water is present but you might not ever be able to remove the sink.

    Bookmark   October 14, 2010 at 12:52PM
Sign Up to comment
More Discussions
Hubby and I disagree on who to call for cracks
So we keep arguing for like 5 years now (husband and...
dahoov2
Water Drip Stain on Roof Fascia?
My roof edge on the corners of the front porch is leaving...
pbx2
Need a professional locksmith service!
Hey guys, I am new to this forum and the reason I registered...
martin-ferdinand
Siding advice for chimney
Hello and thanks in advance for any advice. Yesterday...
andreadeg
concrete over concrete?
I have filled the space under my front door threshold...
robinasq
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™