Re: Clicker remote for Liftmaster garage door

shhhhJune 9, 2010

Hi!

I just bought a clicker remote (chamberlain KLIK1U)a week ago and programmed it to use with our Liftmaster Garage door. It worked fine for a week but yesterday I dropped the remote on the garage floor and since then it has stopped working. I removed the battery and put it back again but nothing seems to be happening.

IS there anything that I can do to fix it or do I need to just buy a new one.

Thanks!

Ash

Thank you for reporting this comment. Undo
don_1_2006

The only thing I can think of is to check the circuit board for cracks or loose connections. Check to make sure the connections to the battery are still tight and not broken. These things are usually pretty tough.

    Bookmark   June 9, 2010 at 4:12PM
Sign Up to comment
More Discussions
Need advice for gap under door frame
Hi, We had a contractor install pre-hung interior doors,...
pam27d2001
adjusting stop on lazy susan
Hi all, I have recently moved into an older home with...
blakekr
How to safely pull down attic stairs in 12' ceiling
Hello all, I am buying a house with 12' ceilings and...
ricewalker
Sagging Anderson Storm Door
I had an Anderson storm door installed a couple of...
gridgedad
Door knob
My front door knob screws won't stay tight so if I...
padfoot4768
Sponsored Products
Sea Side Satin Nickel Ceiling Fan
$480.00 | Bellacor
Zaneen | Invisibili 8 Inch Adjustable LED Recessed Lighting
$504.00 | YLighting
Tommy Bahama Island Estate Lanai Outdoor Fire Pit, Patio Furniture
FRONTGATE
Cambridge Urban Stone Gray Paint Shaker Kitchen Cabinet Sample
CliqStudios Cabinets
Strap It Accessory by Smart & Green
$53.00 | Lumens
American Drew Grand Isle 7 piece Rectangle Dining Set - ADL4263
Hayneedle
Geometric Groove Platter
$59.99 | Dot & Bo
New Veg Dyed Geometric Blue-Red Balouch Runner Hand Knotted Wool Rug P23
BH Sun Inc
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™