Measuring for a new door & frame?

bassadict69October 14, 2010

I am needing to replace an old exterior door and am not sure how to measure...do I simply measure the existing door?

I will be replacing the whole unit...jamb, door, everything! This will also be my first such venture, so it could get interesting! LOL!

Thank you for reporting this comment. Undo
HandyMac

Measure the door from side to side, and top to bottom.

If you buy a prehung unit, it will be listed as a 36" by 80" door. The rough opening---the hole where the door is installed will be larger to allow room for the door frame. Something like 38" by 82".

You will need:

A book on replacing an exterior door.

Long level---minimum 4' long---6' is better.

Shims---I prefer the cedar ones(traditional) but composite shims are available.

3" long screws---to replace at least one screw in each hinge on the frame side. That will lock the door frame into the house frame.

Tube of thresh hold sealer---for sealing under the thresh hold. The specific sealer never hardens, which keeps the space unter the plate sealed.

I use finish head screws to install doors. You push back the weather stripping and drive the screws through the door frame into the house framing, using the shims to keep the frame straight and plumb.

There is much more to the job, so read the book carefully. You can get one at a home improvement store.

    Bookmark   October 15, 2010 at 1:36AM
Thank you for reporting this comment. Undo
bassadict69

Awesome...Thanks for the info!

I will definitely be going the prehung route!

    Bookmark   October 15, 2010 at 9:30PM
Thank you for reporting this comment. Undo
mike_kaiser_gw

What Mac said! When you measure the existing door it will be a little smaller, maybe 35 3/4" that's a 36" door.

You'll also need to know what "hand." An easy way to tell is stand in the door opening with your back against the hinges. Your hand that moves in the direction of the door swing is the "hand". So if you left hand moves, it's a left hand door. You'll also need to know if the door opens in or out. So you'll be buying something like a left hand, in-swing door.

Don't buy the little pine shims they sell in every home center right next to the doors. Wander over to the building materials department and buy a pack of cedar shims. They come in a bundle much bigger than you will need but they make great kindling if you have no other use for them. After you've installed the door, you take a utility knife and score the shim. Whack off the remainder with your hand. Pine doesn't whack very well. :-)

    Bookmark   October 16, 2010 at 8:40AM
Sign Up to comment
More Discussions
How does a General Contractor work...do I need one ?
I am new to remodeling anything in my house. I have...
jeannette10
What kind of awning can I add with this roof line?
Hi All, We want to add an awning outside of our front...
tmolly
Design and Planning a Remodel/Addition on a Budget
I bought my first home three years ago and had grand...
gzehnder
"Green" Remodeling - where to start?
We would like to remodel using materials and processes...
prairiemoon2 z6 MA
Bad Countertop Fabrication
Hello, Hoping to get some advice/opinions! We just...
diynola
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™