Craftsman Garage Door Opener Safety Sensor

rossjrJanuary 28, 2012

I have an older 1/3 hp Craftman (139.53200)garage door opener that did not come with safety sensors (although they were available as an option:pt#G53710 no longer available) I also have a newer 1/2 hp unit (139.53628SRT) with sensors (pt#41A4373)that are still available for purchace.

Is it possible to wire these sensors to the older units and have them work successfully? If so, how? Or are there other sensor available that will work with the older units?

Thank you for reporting this comment. Undo

There is no way to add sensors to your old opener. The option available at the time it was new included a logic board. The logic board in your opener will not accept sensors.

    Bookmark   January 30, 2012 at 10:04AM
Sign Up to comment
More Discussions
Fixing a small drywall mark?
I accidentally tapped the corner of my iPad against...
Gable Vent Color Suggestions- Insight please
Hopefully someone can give me insight! We recently...
T1-11 siding: Replacing rusted z-flashing?
I have several questions about z-flashing for T1-11...
Removing mold from joint compound container
I have a container of Sheetrock All Purpose Joint Compound...
Pouring a new driveway
Hello everyone, first time poster. I'm ready to sign...
Sponsored Products
Crate Mattress and Crate Cover Set
$299.00 | FRONTGATE
FANMATS Door Mats Syracuse University 18 in. x 30 in. Door Mat Team Colors 11382
$14.88 | Home Depot
ClosetMaid SuiteSymphony 25 in. Starter Kit - 8869
$147.99 | Hayneedle
Homelegance Chicago Double Pedestal Dining Table in Deep Espresso
Beyond Stores
39 Inch Bathroom Vanity Set
Roped Rectangular Doorbell
Signature Hardware
Silver Tru-Grasp Swing Accessory Organizer
$9.99 | zulily
Ultra Thin Garage Floor Runner
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™