Craftsman garage door opener repair

gleenJanuary 2, 2011

I have a 1/2 HP craftsman garage door opener, Model # 139.53660SRT1. I had a problem with the door: when I would push the start button the chain would move about 1-1/2 ft. and then automically return to where it started from. After finding this forum site I read about someone with a similar problem and I changed the RPM sensor and it corrected the travel problem. My problem now is that I cannot get my remote to program. The door works fine from the wall control button. I thought my remote was getting old and maybe needed replacing so I purchased another but neither one of the remotes want to program. I tried clearing the memory in the opener and then tried to program the remotes but I am not getting the flash of the light that should occur when you reprogram a remote. The remote I just purchased seems to be the same part but the only thing that I noticed is that the new remote only has one 3 volt battery. My old remote had two 3 volt batteries. Can this be the problem?

Thank you for reporting this comment. Undo
gleen

If the remote I have is correct, what could make it not program?

    Bookmark   January 2, 2011 at 7:45PM
Thank you for reporting this comment. Undo
don_1_2006

I think your logic board has quit working.

    Bookmark   January 3, 2011 at 9:38AM
Sign Up to comment
More Discussions
Should we raise/fix concrete slab in driveway or wait?
Just moving into a new house this month. So the inspector...
mattsk42
Insulating an inaccessible crawl space?
My 1940s bungalow style house sits on a crawl space...
blessedbe
Need a professional locksmith service!
Hey guys, I am new to this forum and the reason I registered...
martin-ferdinand
Stranges lines in frost pattern on roof
I have these lines on the roof when there is a frost....
cswartzwelder
Leaning picket fence
I recently purchased my house and for whatever reason,...
media529
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™