Where to put faucet on sink with drain on the right?

heidihausfrauApril 26, 2013

I have a silgranite super single and am confused about where the faucet should go. In reading up on sinks and faucets, I saw that the faucet needs to go above the drain to minimize splashing. But my KD said to line the faucet up with the center of the window for aesthetic reasons.

What have others done with single drain sinks? Did you like your decision?

Thank you for reporting this comment. Undo
jellytoast

In searching for sinks and faucets, I found that it was nearly impossible to line up the water stream with the drains, espcially since many sinks these days have offset drains. I'm wondering if the written advice circulating out there is outdated ...? My drain is to the rear of the sink and finding a faucet that lined up with the drain would mean that my water would be coming out at the rear edge of the sink ... not practical. The water stream from my faucet hits in the center of the sink, not into the drain, and there is no splashing. You may have more or less splashing depending on the height of your faucet and the depth of your sink. But do yourself a favor and don't get bogged down by that water-into-the-drain "requirement."

This post was edited by jellytoast on Fri, Apr 26, 13 at 13:25

    Bookmark   April 26, 2013 at 12:49PM
Thank you for reporting this comment. Undo
rococogurl

Lining the faucet up over the drain is a basic. It also is the optimal installation but not a "requirement" and never has been. A lot of these decisions are purely aesthetic and dependent on the sink.

This comes up over and over. If it's considered essential well and good because that at least saves someone from an unhappy surprise.

Many big sinks now have drains to either side. The faucet can be installed successfully over the drain or not as we've seen so many times.

Some people like asymmetry; some not. Some have one faucet with integral sprayer; others (like myself) have a seperate sprayer and faucet. Each suggests different options.

Then there's the splashing issue. The taller the faucet and the shallower the sink the likelier the splashing. However, water pressure is also a factor.

I have a left-side drain and my faucet is not installed perfectly over it (although that would have been idea) because it looked awful particularly because my sprayer is bigger than the faucet. It's been fine.

    Bookmark   April 26, 2013 at 1:42PM
Thank you for reporting this comment. Undo
a2gemini

My philosophy on this differs slightly after reading an article on faucets. I always thought they should squirt directly down the drain but the article said the cause of splash is uneven surfaces - so when the stream hits the disposer flanges - it splashes - Ours is lined up over the drain but lands about 2-3 inches in front of it - the drain is to the right side (Cascade Silgranit)
My only regret was not getting the taller faucet that would come out 2 inches further.

    Bookmark   April 26, 2013 at 4:32PM
Thank you for reporting this comment. Undo
Angie_DIY

Is yours a Bianco Diamond Super Single with an offset drain like this one?

You may have be able to have both. The distance from the faucet hole to the center of the drain is about 12". The reach of many high-arc faucets is about 10". Plus, water doesn't usually come straight down from the faucet, but is often angled a bit. Thus, if you put your faucet in the center of the sink, and rotate your faucet towards your drain, the will probably go into the drain.

    Bookmark   April 26, 2013 at 5:34PM
Thank you for reporting this comment. Undo
Caliente63

If you have a double sink your faucet can't line up with both drains. Millions of people have double sinks...

    Bookmark   April 26, 2013 at 6:00PM
Thank you for reporting this comment. Undo
ak0402

I have a rectangular stainless steel sink with offset drain to the right. My faucet is installed in the center. I would not want a faucet not to be centered with a rectangular sink, as it would look "off". You mentioned the window - my sink is not in front of a window, but if it was, I would still center the faucet over the sink, i.e. its functional center, than trying to center the faucet with the window, which may or may not look awry depending upon where you are in the kitchen. It's so easy just to center it over the sink.

If I want my faucet to be directly over the drain, I swivel it to the right and it is directly over the drain. I typically do that when I am running the disposal. Note that I have a pull-out faucet, not a pull-down. My faucet is a Grohe, with a faucet reach of 10-3/8". Most of the time when I am running the water I do not have the faucet directly over the drain, and I do not have splashing. Pull-out faucets tend to splash less than pull-down faucets, so if splashing is a big concern, I would choose a faucet that is a pull-out.

    Bookmark   April 26, 2013 at 6:16PM
Thank you for reporting this comment. Undo
threeapples

I have a large Kohler Whitehaven and an Herbeau Flamande. The sink is centered on the window and I am thinking of centering the faucet on the sink. I want to hear what distance is ideal between the faucet and handsprayer on a 35" sink.

    Bookmark   April 26, 2013 at 9:52PM
Thank you for reporting this comment. Undo
threeapples

Sorry, didn't mean to hijack your thread--I posted thinking it was mine on a similar topic.

    Bookmark   April 27, 2013 at 8:11AM
Thank you for reporting this comment. Undo
heidihausfrau

Thanks everyone for the great advice! I will put it in the center and turn it when I run the disposal.

No worries 3apples---I have been reading your posts too as I wonder how far away to put my soap dispenser;)

    Bookmark   April 27, 2013 at 12:06PM
Thank you for reporting this comment. Undo
breezygirl

My pulldown faucet (love, love the pulldown vs pullout) is not centered over my drain either. I do not get splashing unless I hold an item at the wrong angle under the water stream while on high. When I run my GD, I purposely aim the water just to one side of the disposal, not directly at it. The water has a tendency to hit the GD flange if aimed directly and bounce away from the drain instead of going down the drain. Positioned to one side, more water goes down the drain to aid in GD grinding.

    Bookmark   April 27, 2013 at 1:00PM
Sign Up to comment
More Discussions
Tile all over range and just one row up elsewhere
I have been looking for backsplash tile and found cheap...
crl_
Suggestions on this kitchen plan
Please give me your comments on this floor plan. The...
12crumbles
please share feedback merillat classic, eastman, armstrong
I've been looking for moderately priced cabinets. Please...
abekker
New to Kitchens? Read Me First!
Welcome! If you are new to the Kitchens Forum, you...
buehl
37" or 30" cooktop?
I was planning on a 30" induction cooktop which...
12crumbles
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™