Air Flow fault Pentair MinMax

GgrifDecember 16, 2011

I searched the forum but did not find the answer to my particular problem. Hope someone can help.

Background: I installed my MinMax in 2005. It is only used a few times each year. About a month ago I had my pool and spa re-plastered with pebble tec. I replaced my pool pump yesterday with a Pentair VS unit.

Today I tried running the heater, nothing happens. The only error is one blink from the red LED inside the case which indicates an Air Flow fault. I ran a wire in the fittings at both ends of the air tube as suggested by repair guy in another post. I also cycled the power as suggested, again, no go.

The power and pressure LED's are both green, I ran the pump from 900 rpm all the way up to 3100 rpm, made no difference.

Any suggestions would be most appreciated!

Grif

Thank you for reporting this comment. Undo
muddy_water

This is the best place to go for Pentair equipment problems

Here is a link that might be useful: Pentair

    Bookmark   December 17, 2011 at 8:43AM
Thank you for reporting this comment. Undo
poolguynj

Most likely a dying fan. The air switch is generally quite reliable. Is the air line from the switch to it's manifold port connection properly connected and intact?

Scott

    Bookmark   December 17, 2011 at 9:50AM
Sign Up to comment
More Discussions
Atlantis pool and spa (Magnolia Tx) anyone have any feedback?
Searching for a pool builder and looks like Atlantis...
makingbeacon
HELP!! Pool color and pricing with Pebbletec
Help please and fast!! When we started our pool I told...
tonyagrieser
AquaShield pool enclosure
I have AquaShield pool enclosure for less than two...
aquashield2
Pool resurface question
I am having my pool resurfaced and the supplies were...
lbrandt5
Obsessing over pool finishes
Hello all, I am looking for any and all advice on pool...
megankheaps
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™