Aqua Logic No amp reading

BrianDalJuly 16, 2011

I have a Aqua Logic pool system. Just recently I have received an error code that is from the control board reading zeros for the amps and zeros for the salt content as well. I still have a reading for the volts going to the cell. I was wondering if there is a fix for this besides replacing the expensive control board. Any help would be greatly appreciated.

On another note, I have flagstone around my pool and spa as well that seems to be deteriorating from the salt water. Is there any sort of sealer that will stop this from happening or am I just going to have to replace it in a few years?

Thank you for reporting this comment. Undo

See . This is not an unheard of event as the site will show you.


    Bookmark   July 16, 2011 at 11:42PM
Sign Up to comment
More Discussions
J.L. Blodgett abandons pool project
I wanted to send along a note of caution to all members...
Obsessing over pool finishes
Hello all, I am looking for any and all advice on pool...
Automatic Pool Covers for Inground Swimming Pool
We are looking to purchase an automatic pool cover....
Christy Bell
Swimming laps- Design help
My wife wants to swim laps. Short of building an olympic...
I will answer pool plaster questions
For 23 years I was in the swimming pool plaster industry...
Sponsored Products
Supreme Air Antique Verde With Gold 56 Inch Blade Span Ceiling Fan And Blades
$196.20 | Bellacor
Kinetic Collection Brushed Chrome Pleated Plug-In Swing Arm
Lamps Plus
Set of Two Parrot Zikmu Wireless Stereo Speakers
Medium Gray Aqua Shield Naples Weave Mat
$29.99 | zulily
Bed Side Lamps: Reading Room 21-3/8 in. Table Lamp P211-084
Home Depot
Current Magazine Holder in Red
$99.00 | LexMod
Access Lighting Unagi 70019LED Gooseneck Headboard Wall light - 70019LED-BRZ
$120.00 | Hayneedle
Lucky Fish Aqua Outdoor Rug (1'11X7'6)
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™