Need help with an older Hydro Spa

BadmoonrisingJune 1, 2012

Hello ! I have an approximately 16 year old Hydro Spa, Model "The Stamina". It's been relatively problem free (only had to replace a motor a few years ago). One night last week, I noticed the pump is running constantly. Went out and the control display was reading 100 degrees and none of the control buttons would operate. The pump was running constantly on low speed. I went inside and tripped the breaker for the hot tub, waited a few minutes and turned it back on. After that, the control display is dead (nothing lights up). Looked in the panel and the connector going to the motor was brown and burnt at the white wire. I repalced that connector thinking that may have fried one of the fuses. All fuses tested good with an ohmmeter, switch is good and I can hear a relay click on when the switch is turned on, but nothing else works. Nothing on the display as if it has no power.

I then tested for a full 220v between the red-black (ok) and 120v between white-black and white-red(ok). There is a red LED on the board that lights up when the switch is turned on.

Flipping the board over, one of the relays appeared to have a burned connection (looked as if someone had de-soldered that connection). I re-soldered that. Still no dice. Any ideas on what the issue is and how to I test the board or control panel to see what has gone bad ? The controls and board are a Hydroquip CS6100 unit.

Thanks !

Thank you for reporting this comment. Undo
poolguynj

Once the relays on a board go, I replace the board. Unless you have a full test set for fixing boards, I suggest you do the same. You seem to have the skills to do that so it will save you some money.

Scott

    Bookmark   June 3, 2012 at 6:37AM
Sign Up to comment
More Discussions
Swimming laps- Design help
My wife wants to swim laps. Short of building an olympic...
jparkfire
Looking for opinions on pool companies South Jersey...
Also, suggestions for whether people liked their tanning...
Karyn Kettleman Van Buskirk
Pool resurface question
I am having my pool resurfaced and the supplies were...
lbrandt5
should pool building take this long??
I signed a contract July 19th with Mr. Carlos pools....
animallover5
Need help with sealing gunite to rock, and black alge
Hey friends! I purchased a house last summer in Houston,...
Klint Turney
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™