Arbor Swing Help?

blakeasJuly 3, 2009

I am trying to make these 4X4 trim pieces - But using my mitre saw I keep on getting them to turn out different with different slopes. How do I do i correctly?

Thank you for reporting this comment. Undo
weedyacres

These look like blocks just cut off squarely??

Can you post photos of two blocks with "different slopes?" I'm not quite picturing what you're talking about.

In general, if you push the length of wood against the saw's fence, you'll get a square cut. Unless the wood is bowed.

    Bookmark   July 5, 2009 at 5:11PM
Sign Up to comment
More Discussions
TWP and One Time stain...2 years later
I built a deck in the summer of 2009. Decking was garapa...
weedyacres
clear roof over patio
I would like some advice/help with the clear roof over...
ktmast
How bad is this- builder did not use stainless screws on ipe?
I have a mess on my hands and would appreciate any...
LaylaJane
Best concrete sealer to prevent salt damage? Any virgin concrete
I'm not sure which part of the forum this question...
growingadvice
Best material for a covered porch flooring
Hi all. I need to replace a covered porch floor...again....
Mags438
© 2015 Houzz Inc. Houzz® The new way to design your home™