Post subject: Need pinouot for flow switch on Aqua Logic AQL-P-4

KevinRDMay 17, 2011

I'm getting the no flow error on my Aqua Logic P-4 control panel. The board was replaced about 16 months ago from what I guess is a well known defect. I know it could still be the board but I suspect it's probably the switch since it's 4+ years old. I'd like to check it out first to make sure before I buy a switch. I should be able to just simulate a closed switch by putting together a jig with a telephone connector\cable and shorting the pins together by twisting the appropriate wires together. Problem is my eyesight isn't what it used to be and I can't tell which two pins are being used.

I've searched the net and couldn't find a reference for a pinout on this connector. Does anyone know where one is?

Thanks

Thank you for reporting this comment. Undo
    Bookmark   May 17, 2011 at 11:49AM
Thank you for reporting this comment. Undo
KevinRD

I think that manual is for a newer model. I did locate the equivalent installation manual for my controller a couple days ago but like this one it did not get down to the detail of pinouts on the board\connector.

Thanks for trying to help, though.

    Bookmark   May 17, 2011 at 6:12PM
Sign Up to comment
More Discussions
Pool builder search sugar land, tx
Hi guys! Were closing on our brand new home in sugar...
mtrade01
New Pool in Louisiana
Wanted to share a few pictures of our new pool. It...
trhought
pool filter leak; newbies buying the house
We have a contract on a house with a pool. The pool...
defgarden
Is it safe to build a vinyl inground with pyrite in the soil?
I have been trying to find information about excavating...
jo229
Plaster mottling???
It's been 13 days since we had the pool replastered....
lisadlu
© 2015 Houzz Inc. Houzz® The new way to design your home™