T&P relief valve

bibbusOctober 14, 2012

the flex line on my 50 gal GE Smart Water tank had a pin leak and I replaced it myself. I also drained the tank since it had been a long time. The water was clear when I first opened the valve at the bottom. I emptied a gallon or two before hooking up the garden hose and draining the entire heater. I refilled the tank and turned it back on and it seems to be working fine, except that when I test the t and p relief valve, it pours out water. I've tested it several times in the 24 hours since the repair. No air comes out - only high pressure water. What could be wrong?

Thank you for reporting this comment. Undo
randy427

It SHOULD be water that comes out of the T&P. Your water heater does not have an air-charge.

    Bookmark   October 14, 2012 at 7:47PM
Sign Up to comment
More Discussions
the dreaded frozen pipes...
Hello all, I hope someone out there can help me. I...
kineala
troubleshooting thermostatic valve for shower
troubleshooting thermostatic valve, no hot water and...
bathroomblues1
New under mount sink - drain off-center?
I had a new granite countertop installed with an under...
mike_lee2
Septic tank and question on the "Sponge"
I have a septic tank that when last pumped out had...
big_al_41
shower problem....can someone give me a clue?
My hot water plumbing JUST started acting "wonky."...
bevangel_i_h8_h0uzz
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™