Well, pump, tank, and 'pump house routing

KDF5August 30, 2011

New to this forum. We just bought a used home with a newer well. We have a holding tank, Well and a separate small "pump house" building that holds the pressure tank, 1/2 hp pump. Both the well pump and the pressure pump run a 20amp circuit.

Problem 1. In the "pump house" the pressure tank is plumbed into the current well and the old well with not visible shut off. Also the irrigation system is "T" in to this same plumbing. It is a horrible plumbing job with spare elbow propping up where the pressure pump line t-off to the pressure tank then into the house through a sediment filter. â¨

Q. Should the second well be disconnected from the circuit? It is still wired and the well is more seasonal. (I have not attempted to turn it on, as I don't want to push rust and sediment in to the house.

Problem 2. We suspect where the well plumbing connects in to the water line that runs from the holding tank to the "pump house" is just a "T" connection. Which I have been told is causing cavitation and air to end up in our lines.

Q. Is this really a problem? Seems to me that the biggest issue is the holding tank (3,000 gal) is not turning over water at all. Water quality is more the issue with a seemingly stagnant tank of water?

Last Question, does aerating my water into the holding tank really eliminate the sulfur smell in all our water?

The holding tank has a float system connected to the well pump; the pressure pump is correctly connect to the pressure switch at the pressure tank and holds 80 lbs with our leaking.

Let me add one more thing, they directly connected the irrigation to the system on the outside of the "pump house" with only a T handle.

Q. Should this be separate?

I know I can fix it, but where does one start? I want to start with plumbing at the well, and let the water enter the holding tank from the top rather than the bottom as it does, and let it aerate the tank to get rid of the sulphur odor. (I will vent the tank as well.

I know this is a lot but I need to get moving on this before winter sets in.

Any ideas or diagrams or websites would be appreciated.

Thank you for reporting this comment. Undo

So, let's see if I read this correctly.
You have two wells that feed into a 3,000 gal. holding tank. One pump is not currently used. The pressure pump feeds the house and an irrigation system.
You have an odor in the water and you don't use the second well, but have sufficient water.

"does aerating my water into the holding tank really eliminate the sulfur smell in all our water?" - I doubt it. FWIW, changing the pressure tank got rid of the sulfer smell in my neighbor's water. It was the tank, or the bladder in it, that was the culprit.

My suspicion is that the holding tank was put in to ensure enough water to meet the household/irrigation demand in times when the well couldn't meet the needed flow rate. (Are you sure the tank meets sanitary standards for household water?) That may be why you also have a new well. I would not have them on the same circuit or connected to the same plumbing system, especially if one were in questionable condition.

    Bookmark   September 10, 2011 at 10:42AM
Sign Up to comment
More Discussions
how to turn off dual water handle on kitchen valves
I need to turn off water to kitchen sink. We have...
Fleck 9100 SXT Programming/Settings
I am finally installing my new Fleck 9100 SXT!!! Thanks...
Fed up and ready to tackle my well water issues
I've been reading posts trying to educate myself for...
Salt-free water conditioning
Hi all, Considering installing a water softener in...
Details of a new residential water service
I'm in the planning stages of replacement for my 55...
Sponsored Products
Diane 'Eddy' Teal Bench
Quoizel Uptown Theater Row 30" Wide Silver Bath Light
Lamps Plus
Esperanza Antique Bronze Twenty-Seven Light Chandelier with Clear Royal Cut Crys
Designers Fountain 84103 Bradley 3 Light Bath Bar in Charcoal Finish - 84103-CHA
$379.50 | Hayneedle
Chooty and Co Findaly Apricot Euro Sham - Set of 2 - CHO5244
$117.98 | Hayneedle
Stilo Bronze One-Light Incandescent 120v Mini Pendant with Flat Canopy Stem and
$234.00 | Bellacor
6' White Pressure Treated Post
Mia Chrome Three-Light Bath Fixture with Marble Grigio Glass
$391.50 | Bellacor
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™