Secure drain line without access

atdevJuly 14, 2013

I am trying to add a utility sink in our garage in a house with a finished basement.

There is an area between the two floors where I can run the drain with enough slope to connect to the main drain line of the house. However, the problem is it would be about 18ft of pipe. I wouldn't have access to the area where I run the pipe, but am only pushing the pipe through to the other side. The problem is securing the drain pipe as I don't have access to the middle area where the pipe runs.

Any ideas or suggestions? If it is a simple drain line for a utility sink should it still be secured somehow besides at the two ends?

Thank you for reporting this comment. Undo
PRO
Sophie Wheeler

18" is much too far for a run. You're going to have to do something else regardless.

    Bookmark   July 14, 2013 at 11:28PM
Sign Up to comment
More Discussions
Culligan HE vs Kinetico Premier vs Fleck
Hi, After doing some research regarding the above water...
blessedmomof4
corrosion seen on hot water shutoff valves
I was repairing a minor leak in the kitchen faucet...
jastrong5
Am I the only one bothered by this?
Since Houzz took over, these forums have become a spam-infested...
aliceinwonderland_id
toilet flapper closes too fast
a 5 y.o. AS 4396 w/Fluidmaster guts. The flapper is...
fritzgarden
Can we bypass old hot water heater?
Any reason we can't bypass and then remove this old...
shellking
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™