Shower stalled retiled - surround not fit now

ccurrerMay 24, 2013

Hi....we re-tiled the shower stall with travertine that is a little thicker than the porcelain that was there before. It is a quadrant shower stall and now the surround is just a little out of fit (because I used about 40mm more of the room with the thicker tiles). I would just squeeze the suround in but I'm afraid that it will then bend out the wall brackets and cause leaking. I would try and bend it permanently but am fearful of going too far....any advice? It's a 40mm misfit on a 1200 x 900 surround....

Thank you for reporting this comment. Undo
PRO
Sophie Wheeler

If by "surround", you mean the framing for the door, then no, you don't "squeeze" that. You buy a new door if the one you have doesn't have adjustability built into it.

    Bookmark   May 24, 2013 at 4:29PM
Sign Up to comment
More Discussions
Hard Water or What?
We are renting an older duplex home in CT, and the...
roysterfam
Can we bypass old hot water heater?
Any reason we can't bypass and then remove this old...
shellking
Rainfresh water filter leaks from top.
I have a Rainfresh water filter. It seems to be leaking...
gtrshop
Warm water mornings on cold line for 30 secs....
We have been living in a home built in 2011 (in Canada)...
nikolaos2012
New under mount sink - drain off-center?
I had a new granite countertop installed with an under...
mike_lee2
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™