does this drain fitting exist?

nirvanamike06February 19, 2011

im getting ready to start doing some plumbing work and i know they make all kinds of off the wall fittings and couldnt find one like this so i made it in ms paint. i also would like one with all 2 inch hubs.

Here is a link that might be useful:

Thank you for reporting this comment. Undo
brickeyee

You probably need to use an actual plumbing supply house.

You can look around Genova to see if the part is even in the catalog.

Here is a link that might be useful: Genova PVC

    Bookmark   February 19, 2011 at 9:53AM
Thank you for reporting this comment. Undo
joed

found this

    Bookmark   February 19, 2011 at 10:19AM
Thank you for reporting this comment. Undo
joed

More stuff here.

Lasco fittings

This page looks like it might exactly what you want. 3x3 with side inlet in 1.5 and 2"

Lasco Page 281

    Bookmark   February 19, 2011 at 10:30AM
Thank you for reporting this comment. Undo
joed

Link is wrong

Lasco Page 281

    Bookmark   February 19, 2011 at 10:34AM
Thank you for reporting this comment. Undo
joed

Link still not working right. Google it.

    Bookmark   February 19, 2011 at 10:35AM
Thank you for reporting this comment. Undo
lazypup

The fitting that Joed ed has posted above is a 3x3x2 low heel inlet closet bend, but it is upside down in the illustration.

They also make side inlet closet bends that are configured like the fitting your looking for but I don't beleive they make it in 2".

Also be very careful. That is a specialty fitting at it is very limited were it can be used.

Perhaps if you could tell us what your trying to hook up we can help you find a solution

    Bookmark   February 19, 2011 at 10:36AM
Thank you for reporting this comment. Undo
nirvanamike06

the venting for my shower, i have to run it up the wall and tie it into the main vent stack, the stack is 3 inch and the shower vent will be 2 inch. i could just use a tee but i thought its be easier if they just made a fitting like this.

    Bookmark   February 19, 2011 at 10:53AM
Thank you for reporting this comment. Undo
lazypup

Code prohibits running a horizontal vent under the floor. A vent must rise vertically until it reaches an elevation 6" higher than the flood level rim of the tallest fixture served by that vent.

    Bookmark   February 19, 2011 at 11:12AM
Sign Up to comment
More Discussions
Toilet swirls, but won't flush!!
Very frustrated. The toilet seems to be ok, it gets...
edweather
Garden Hose iced over
Ok, I know I was stupid. I'm new to home ownership...
Cassandra
Fire Sprinkler
Purchasing a home with an indoor fire sprinkler system....
jglo
toilet flapper closes too fast
a 5 y.o. AS 4396 w/Fluidmaster guts. The flapper is...
fritzgarden
the dreaded frozen pipes...
Hello all, I hope someone out there can help me. I...
kineala
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™