Lakeside anvil

bobborenoOctober 19, 2012

I have an anvil with the Lakeside foundry mark on the side of the anvil with the horn facing right.Under the horn on the foot of the anvil are 2 sets of marks.On the left side of the base is an 80 and starting about at the middle it reads A143721.I was not able to weigh it but the dimensions of the base are 9 1/4"L X 7 5/8"W.It's overall height is 9 1/4" and is 21 3/8" long.It does have an hourglass shaped indentation on the bottom as well.Can you give me any information on it's age and worth?

Thank you for reporting this comment. Undo
bobboreno

Here is a photo of my LAKESIDE anvil.

    Bookmark   October 19, 2012 at 9:49PM
Thank you for reporting this comment. Undo
bobboreno

I found out this anvil is made by "The Columbus Forge and Iron Co." the same company that makes Trenton anvils and from the serial number I found out it was forged in 1916.

    Bookmark   October 22, 2012 at 7:37PM
Sign Up to comment
More Discussions
Copper bar top
I'm planning to use copper sheeting to finish my basement...
jedijoe1
Copper sinks dont drain
I have a under mount copper sink installed in a granite...
eltrecero
Painting Galvanized Metal
What's the best way to paint galvanized metal(exterior)?...
vic99
metal compatibility
I have a built in gutter on my gable roof. The gutter...
dustynight
DIY copper countertop #2
Since the last thread on this topic has reached capacity,...
cleanclassic
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™