Metal Studs

pete_p_nyOctober 22, 2007

I bought some metal studs to frame around some soffits.

Felt it would be easier to snip and work my way along.

However, those metal stud metal scews...they stick out from the surface of the stud a bit...what happens when you install the sheetrock...does it rest on the surface of the screw? Does it intent into the screw. I am envisioning it looking lumpy because it the sheetrock will rest on "top" of the screw at the stud connection to the top/bottom rails, but then suck in a bit on the areas away from the screw. I know I must be interpreting all this incorrectly because they are used frequently. But I am very curious.

Thank you for reporting this comment. Undo
brickeyee

The drywall is normally pressed hard enough to dent over the screw heads.

    Bookmark   November 10, 2007 at 3:12PM
Sign Up to comment
More Discussions
Painting Galvanized Metal
What's the best way to paint galvanized metal(exterior)?...
vic99
HELP!! Patina off copper sink!
I love my copper sink with its dark patina but there...
bichonluver3
Copper bar top
I'm planning to use copper sheeting to finish my basement...
jedijoe1
change bolt lock on inside of door but not out?historical sort of
Hi. We bought an old house and are changing all of...
Bridget Helm
Place in SF Bay Area to get a metal railing made?
Looking for a recommendation for a metal shop in SF...
chaus7
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™