Question about homemade metal bender?

algreenJanuary 26, 2005

I was recently searching through the web for articles on homemade metal benders, I found a post that was started sometime in september on this forum about a homemade bender that a few of the members had built, the posting was entitled My home made metal bender, and it was posted by kbeitz. The bender looks very good, but I have a few questions. My first question would be, is the bender able to bend structural tubing without kinking or creasing the metal? My second question is, is their any specific measurements that you can give me so that I can build the bender? Any help would be greatly appreciated.

Thanks

Algreen

Thank you for reporting this comment. Undo
kbeitz

It will bend structural tubing with adapters with out kinks...

    Bookmark   February 4, 2005 at 8:36PM
Thank you for reporting this comment. Undo
kbeitz

It will bend structural tubing with adapters with out kinks...

    Bookmark   February 4, 2005 at 8:37PM
Sign Up to comment
More Discussions
Copper bar top
I'm planning to use copper sheeting to finish my basement...
jedijoe1
Need help - bending a short steel pipe
Hello everyone, I need some suggestions on how to bend...
jungleman
Place in SF Bay Area to get a metal railing made?
Looking for a recommendation for a metal shop in SF...
chaus7
Copper deck railing system
Patio deck on our home was 4"x4" wood posts...
tridogdude
Problem with SCALANCE X101-1 and Cisco Switch ?
I really don't know what do this happen when i try...
Jasmine01
© 2015 Houzz Inc. Houzz® The new way to design your home™