Cast iron to steel?

brucemanJanuary 19, 2005

Is it possible to weld cast iron to steel effectivly using a stick welder? I tried using 7014 rod. It wasn't pretty. The steel adhesion was fine but it popped off the cast when I pushed on the two pieces.

If anyone has any advice or tips, I would sure appreciate it.

I also have a oxy/acetylene torch.

Bruce

Thank you for reporting this comment. Undo
blacksmithman

To weld cast iron you need a rod with nickel in it. Check out the site below.

http://www.mylincolnelectric.com/Catalog/consumabledatasheet.asp?p=16774

Here is a link that might be useful: Lincoln Electric

    Bookmark   January 19, 2005 at 8:17AM
Thank you for reporting this comment. Undo
bruceman

Thank you, sir.

    Bookmark   February 3, 2005 at 12:03AM
Sign Up to comment
More Discussions
Copper bar top
I'm planning to use copper sheeting to finish my basement...
jedijoe1
Need help - bending a short steel pipe
Hello everyone, I need some suggestions on how to bend...
jungleman
Bumper or pad for Gate Slamming?
Hi, I have a metal gate that has closed/slammed so...
akarinz
DIY copper countertop #2
Since the last thread on this topic has reached capacity,...
cleanclassic
Copper sinks dont drain
I have a under mount copper sink installed in a granite...
eltrecero
Sponsored Products
Campania International Longwood Egg & Dart Cast Stone Urn Planter - P-472-AL
$609.99 | Hayneedle
Stainless Steel Outdoor Post Mt 1-Light
PLFixtures
Progress Lighting Posts Arts and Crafts Collection Weathered Bronze 1-light
Home Depot
Walker Leather Loveseat - Brighton Polinesia Blue
Joybird Furniture
Arteriors Home - Clint Side Table - 2034
Great Furniture Deal
32 Inch Stainless Steel Undermount Double D-Bowl Offset Kitchen Sink - 16 Gauge
eModern Decor
Dripping Capiz Chandelier
$1,225.00 | Horchow
Quoizel 'Kyle' Mini-pendant
Overstock.com
© 2015 Houzz Inc. Houzz® The new way to design your home™