renovating 1987 manufactured doublewide

dana11January 9, 2009

I would like to know how to reinsulate floors and walls. Also I plan to gut the bathroom and put in walk in shower, new vanity, medicine cabinate toilet and floor. Any suggestions, advice would be appreciated greatly.

There is currently a tub surround, looks to be one piece.

We are also taking panneling off...is sheet rock the replacement or wall board? Can insulation be put between 2x4 in wall behind new shower fixture?

Sorry to have so many questions but manuf. homes are new to me.

Thanks

Dana11

Thank you for reporting this comment. Undo
bus_driver

Depending on how the exterior covering is attached, additional insulation may be easiest to do from the outside. No mess inside either. If aluminum attached with exposed screws, remove the screws and loosen the aluminum panels a few at a time. The top of the panel may be captured by the roofing and cannot be loosened. But insulation can be tucked up to the top anyway. Be careful not to compress the insulation as this lowers the effectiveness.

    Bookmark   January 16, 2009 at 12:03PM
Sign Up to comment
More Discussions
Insulating an older Mobile home
HI, Im new to the forum. Glad to meet you all and really...
txchick
Looking for advice, might be buying manufactured/modular
Hi! My husband and I will be looking at this house...
Turner58800
Moving an old Windsor (70's) single wide SAFE?
A friend of mine has a 1970 ish Windsor 14X 70 or 12...
poaky1
Do You Love Your Mobile Home?
Hi there. I have read the posts on this forum with...
frenchkitty
Good or bad brands Manufactured homes
I am near the point of purchasing a manufactured home...
jackofalltrades_1956
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™