Opinion on Socket Extender needed for Cree CR6

hehatemeApril 21, 2011


I recently went through a tough install of Cree CR6.

There was no way to dislodge the receptacle where the light based needed to be screwed in.

I came to know about Socket extender that screws into the receptacle. I found a few different socket extenders at Amazon.com. Before I try to use it I was wondering if they are safe.

Thank you for reporting this comment. Undo

I have never encountered any indication that they are unsafe. Buy a reputable brand, not cheap knockoffs.

    Bookmark   April 22, 2011 at 12:45AM
Thank you for reporting this comment. Undo

The edison base CR6 is supposed to use a loose socket.

You could try socket extenders - getting just the right length is the tricky part.

    Bookmark   April 22, 2011 at 6:54PM
Thank you for reporting this comment. Undo

Compared with traditional lighting fixtures ,led lights Produce more small current. so more Socket Extender comes to be safe enough .

    Bookmark   April 26, 2011 at 5:49AM
Sign Up to comment
More Discussions
Better to over illuminate living room but add a dimmer?
187 square foot living room. electrician wants to install...
Any opinions on "all-in-one" housing/trim/bulb LED combo kits?
There are a couple "all-in-one" recessed...
Light fixtures for cove lighting
Greetings, I am constructing cove lighting in a small...
MBR ceiling light or fan
Hi all, We have a farmhouse/colonial that was built...
Accent Eyeball lighting for Artwork
Any recommendations for size and type of eyeball light?...
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™