Critter in Heat Duct

JWLuckDecember 21, 2012

Hello all -
This is more a pest in the HVAC system problem (didn't see pest forum, so apologize if I missed it). I have a gas furnace in the basement that feeds to several registers in our single story home. In the last couple months, some nocturnal critter has been scratching furiously beneath a heat register in the furthest (from furnace) part of the house, where the crawl space has least clearance (i.e, the part I can't get to). I popped the register and duct boot was hanging beneath the cutout by a few inches, pulled from the floor. I re-nailed it shut and thought the problem was briefly solved. I also found that a nearby foundation vent had a hole a few inches wide in it, and sprayed foam to seal it.

Nope! The scratching came back at night - but intermittently (1-3x/week). Sounds like something is furiously trying to scrape through the register into the home. Now, little to no heat comes out as well. I believe the critter must have torn some holes in the ductwork based on this. I also cut some hardware cloth and closed the foundation vent again - the critter had scratched/chewed its was through all the foam and the gap was even widened to about 5"across - and left a basement door open at night as an exit.

I know a skunk was living under there this past summer to Fall, possibly making it its den and breeding. Haven't smelled it in last couple months.

Question - does this sound like a skunk (size of hole, nocturnal, known presence)? If so, why would the skunk be obsessed with the duct/heat register? Would they den inside the duct?? Other thought is could be a rat but haven't seen evidence of this...thoughts?

OK - this was quite a rant. Sleepless nights.
Best,
Jamie

(PS-Oakland in SF Bay area)

Thank you for reporting this comment. Undo
energy_rater_la

get under the house to see what damage the
critter has done to the duct.
fix the damage.
after all...someone got under there
to install ducts. get a piece of plastic
and lie on it to scoot into low spots.
use mastics & mastic tape to seal holes.

put poison out to kill critters and
close openings (not foam...critters &
termites like foam on the ground)
use hardware cloth to seal openings.

best of luck.

    Bookmark   December 25, 2012 at 7:03PM
Sign Up to comment
More Discussions
HVAC question
I live near Charlotte NC and have a new Bryant Hybrid...
gtodd1966
Pls tell me the best uses for Carrier Air Handler Model # FV4CNF003
Hi GW, I am stuck with a new 2012 air handler/heat...
ontariomom
Are mini-splits a bad idea.
I have lived in both Europe and the Middle East and...
bry911
Need help with my Heat Pump
I have a 2 ton carrier air handler that is 410-A compatible....
Jason Johnson
Insulating floor on my raised home in Louisiana.
We recently installed solar panels on our home. We...
ktyler1320
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™