Dayton Radiant Tube Heater-Model #7E258-Thermostat

mlutzNovember 2, 2008

I bought a Dayton Radiant Tube Heater (Model #7E258)for my garage. The manual talks a little about the thermostat but it really doesn't explain in detail where to wire it into. I was hoping that someone might have one of these heaters or one similar that could help me with wiring the thermostat. Any help you can provide would be greatly appreciated.

Thanks,

Mark

Thank you for reporting this comment. Undo
zl700

That type of heater requires a line voltage, 120v heating T-stat, like one for electric baseboard, or if you wish to use a 24v stat for better accuracy or setback, a powered isolaton relay will be required.

Reverberray makes daytons heater (Graingers)

Here is a link that might be useful: Wiring on page 18

    Bookmark   November 2, 2008 at 8:45PM
Sign Up to comment
More Discussions
Manual J -> S ->D
JSHR: 0.81 MJ8 Tons: 3.03 SqFt/Ton: 1667 CFM/SqFt:...
Brian S
Rheem Econet AC
Does anyone know when the new Rheem econet Ac units...
bdubb5
Enery efficiency of exposed ductwork?
What are your thoughts on the energy efficiency of...
ccintx
Baseboard heater thermostats
We are looking to install (2) 120v baseboard heaters...
stephja007
Problems with HVAC in 1958 Cape Cod
I've been reading the blogs here and hope that the...
ginaff58
© 2015 Houzz Inc. Houzz® The new way to design your home™