Overflow circuit not working

eddiemarcano1September 17, 2013

I tried to manually push the overflow switch open and the AC does not turn off. I check the circuit and looks good but for some reason I still getting 24VDC at the thermostat key pad while holding the overflow switch open.
Could the little board (relay) be bad

Thank you for reporting this comment. Undo
klem1

Nope. The switch is old school,it's either open ( if pump fails) or closed ( when water level is normal in tank). You either have a defective switch or it has been by-passed.

    Bookmark   September 18, 2013 at 7:19PM
Sign Up to comment
More Discussions
furnace condensation freezing up
A non-profit club that I belong to has a furnace that...
doglover3
Neighbor Finally Upgrades to Heat Pump
My next door neighbor finally took my advice and upgraded...
newtalk2
Nozzle size for Oil Burner ??
I have a Slant fin oil furnace that heats my water...
big_al_41
Insulating floor on my raised home in Louisiana.
We recently installed solar panels on our home. We...
ktyler1320
Baseboard heater thermostats
We are looking to install (2) 120v baseboard heaters...
stephja007
© 2015 Houzz Inc. Houzz® The new way to design your home™