Amana Top Load Washer

Flyrite06January 14, 2012

I have an Amana heavy duty super capacity plus top load washer. It is model# NAV335AWW Rev.27

The problem is the washer doesn't always drain during the spin cycle so the clothes are either wet or the tub is completely full of water at the end of the cycle. This is intermittent, sometimes it drains just fine. Also, if I open and close the lid during the spin cycle the washer will immediately begin draining. If the cycles have all completed and there is water remaining in the tub, if I select the spin cycle again it will drain the water out during that spin cycle. Any ideas or help would be much appreciated.

Thank you for reporting this comment. Undo
cleanteamofny

I would not be surprised if the belt is slipping. It's $24.00 to replace at the Repair Clinic website. While you are under the machine, check the pump to make sure it is spinning freely!

    Bookmark   January 14, 2012 at 6:34PM
Thank you for reporting this comment. Undo
Flyrite06

Thanks! I will try that and post the results.

    Bookmark   January 14, 2012 at 8:15PM
Thank you for reporting this comment. Undo
Flyrite06

I replaced the belt for 24.00 like you said. The pump spins freely. I have run 6 loads without a problem so it would seem that fixed it. Thank you!!

    Bookmark   February 14, 2012 at 10:40PM
Sign Up to comment
More Discussions
speed queen awn 542 and adg3lr dryer
Just purchased Speed Queen AWN 542 and ADG3LR Dryer Great...
bcsnave
Removing ink on silk?
Anyone knows how to remove ink on silk. Much appreciated....
yugoslava
don't buy a samsung washer or dryer
I am in the market for a new set so I called my trusty...
monaw
Do any of you use Ammonia in your laundry?
A friend of mine says she uses ammonia in her wash...
mark40511
Magtag TL leaving white film on clothes
My Maytag has a selfcleaning filter, and I've had it...
sweeterthanhoney
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™