carrier zonekit2zcar

stretch1aMarch 5, 2014

I have a system with a carrier zonekit2zcar installed. I recently added another output on my primary duct, installed a motorized damper, which only closes part of the way. Is there any way to increase the time that the zone control card send the closed & open voltage to the damper? If not is there available a dampner that will work with this controller? I have also installed a damper control card with power supply to allow for the two dampers.

Sign Up to comment
More Discussions
Carrier Greenspeed 25VNA Massachusetts Cold Weather Data
Hello Everyone, I wish I had had this information prior...
Sabs83
Mike_home, is this a good idea? re: thermostat
@mike_home, You wrote this back in 2012 and I just...
cindywhitall
furnace condensation freezing up
A non-profit club that I belong to has a furnace that...
doglover3
Navian condensing combi, good or bad?
Hi, I am looking into converting from oil to gas and...
rickyk22
Is 16 SEER Lennox A/C 5X better than 18 SEER Goodman?
I bought a bank repo home 2 years ago in San Diego....
davidahn
© 2015 Houzz Inc. Houzz® The new way to design your home™