Hardwood floor polyurethane touch up

JohnSullivanNovember 26, 2012

I used a brush to apply a thin layer of polyurethane over the entire floor, and then I used Lambskin to apply a layer of polyurethane to some recently stained floors. 95% of the floor looks great, but there are a few places where the polyurethane soaked in more than others due to the cracks in the old wood and a spot that had some problems and required more sanding between coats.

I am hoping to simply apply polyurethane in a few spots rather than put another layer on the entire floor. Can I just spot touch up the polyurethane, or is doing that going to make it look abnormal or not blend correctly.

Any experience with doing this?

Thanks in advance.

Thank you for reporting this comment. Undo
gregmills_gw

You would be walking a fine line if you did just did a few spots. Typically a stained floor get a minimum of 2 coats of poly. Some opt for a third but two is usually enough.

I suggest you first try spot finish. And you might be ok. But leave yourself the option to coat the entire floor.

    Bookmark   November 26, 2012 at 6:08PM
Sign Up to comment
More Discussions
wood floor finish (am I being too picky)
We recently had our wood floors refinished with the...
Jennifer White Green
What I Learned About Installing Engineered Floors
We just finished installing engineered flooring over...
francesca_sf
My experience: refinish hardwood floors with Bona Traffic
I thought it would be helpful to others to read about...
nanj
Bamboo flooring from LL bad odor
I purchased morning star bamboo strand click flooring...
rg100
We might replace our wood floor with new....
I have 20yr old hardwood floor in our foyer. It is...
cindywhitall
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™