Replace 3 furnaces and AC
I am going to replace my 3 furnaces (one per floor) and my central chiller system for the A/C, I met a lot of contractors and selected 3 final proposals.
I was wondering if you could give me some feedbacks form the following proposal:
Two (2) TUH2B060A Trane XV95 variable speed 2 stage gas furnaces.
Ã¢ÂÂ¢ Two (2) 4TXCC037BC3 Trane evaporator coils.
Ã¢ÂÂ¢ Two (2) 4TTB4018E1, XB14 Trane R-410A split system cooling condensers with pads.
Ã¢ÂÂ¢ One (1) TUH2B060A Trane XV95 variable speed 2 stage gas furnace.
Ã¢ÂÂ¢ One (1) 4TTB4030E1, XB14 Trane R-410A split system cooling condenser with pad.
Ã¢ÂÂ¢ Three (3) a/c line sets from coils to condensers complete with pipe, fittings and insulation.
Ã¢ÂÂ¢ All necessary insulated duct work to be connected to existing ducts with certain retro fit and
adding where needed to satisfy operation, reuse all existing registers and add where needed.
Ã¢ÂÂ¢ Secondary drain pans, float switches, pvc pipe and fittings for all units to be piped to indirect
waste line where necessary.
Ã¢ÂÂ¢ PVC venting utilizing B vent penetration on roof for 2nd and 3rd floor units complete with pvc pipe, fittings and termination fittings.
. Reconnect existing gas line to new furnace complete with pipe, fittings and new gas shut offs.
. Reconnect existing wiring to new furnaces both line and low voltage, reconnect existing condenser line voltage to 1st floor condenser and add 2 new lines.
. Replace Air Bear air filters on all units. 2nd and 3rd floor units complete with disconnect switches and whips with service receptacle .
. Remove 3 new programmable thermostats.
. Remove and dispose of old equipment and all related trash.
. All necessary permits by the Town , gas and mechanical with inspections.
Thank you so much for your help,