craftsman garage door opener sensor problem

fordprtsDecember 12, 2009

my garage door will not close unless i hold down the button on the wall till it is all the way down during the the lights on the sensors come on however they go off and stay off at all other times. I disconnected them and attached them directly to the motor with about one foot of wire the lights still do not come on unless the button is depressed. i think i need new sensors can someone please help thanks

Thank you for reporting this comment. Undo
don_1_2006

Make sure the connections are tight where the wires attach at the rear of the motor unit. I would also pull the logic board and check for loose connections on the printed circuit. It could be the sensors or the logic board that is bad. Only by substitution can you be sure.

    Bookmark   December 14, 2009 at 9:39AM
Sign Up to comment
More Discussions
Sears GDO does not close
I've searched on the forum without any luck. My Sears...
jerseybob_gw
Craftsman 3/4 HP Garage Door Opener w/Extension
I just installed a 9.18450 opener with a track extension...
brian_nb
Good material to patch potholes in old garage floor?
I have some pot holes in my 1963 garage floor. The...
griz8312
Unfinished Detached Carport from 1924
Hi, My house and an accompanying detached garage were...
Central_Cali369
who makes a 10x8 "Carriage House" style garage door?
Perusing the websites of most of the major garage door...
Daniel501
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™