Help on Craftsman 1/2 HP door opener

omahabruceSeptember 10, 2006

HELP- I just repalced the main and worm gear on my Craftsman chain chain drive opener. Model 13953637SRT. Following all of the instructions until instruction #4. Run the opener until the sprocket has completed a clockwise cycle. The Cycle is only 1 second and then reverses counter clockwise for 1 second and quits. I have checked and adjsuted the up and down travel controls and the up and down force limits. Is there another part that may have gone bad?

I went ahead and hooked up my chain and the hooked the door to the trolley. The opener trys to close the door when it is already closed.

Right now the chain is disconnected and my cars are outside.

Any suggestions?

Thank you for reporting this comment. Undo
Don_

Did you remove the black plastic interruptor cup from the shaft of the motor and forget to reinstall it? There is also a quick disconnect with four wires that plugs into the small printed circuit board by the interruptor cup. Make sure it is pushed on completely.

    Bookmark   September 11, 2006 at 1:52PM
Sign Up to comment
More Discussions
Need Help with My SnowBlower
I just recently bought a Craftsman 24" snow thrower,...
bdouble
Garage Door Torsion Spring
Have you noticed that local HomeDepot/Lowes do not...
mister_h
Craftsman Garage Opener Clicks only and LED blinking 5 times
My 1/2 HP Model 139.53641SRT opener clicks to all my...
nosleep
who makes a 10x8 "Carriage House" style garage door?
Perusing the websites of most of the major garage door...
Daniel501
garage door remote opens but wont shut door
I have a 10 year old Craftsman garage door opener model...
Junky
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™