Generator Question - Help Needed

terrykruegerSeptember 9, 2007

OK I have two Troy-Bilt generators. One runs great - no electric. The other had electric, threw a rod. I wanted to combine them (exact same model) but cannot for the life of me figure out how to separate the generator head from the engine. I ripped one of them down to the armature but couldn't figure it out. Any ideas? The one that was w/o electrical had melted brush holder so I swapped it but still no juice. This is driving me nuts!

Thank you for reporting this comment. Undo
formula1

Some generator armatures are connected to the engine cracnkshaft via mating conical surfaces. The end of the engine is typically the male cone and the generator the female cone. A small keyway is included and a long bolt through the center of the generator armature holds it to the engine crank. Try loosening the bolt a few turns and while applying a separating force between the armature and cracnkshaft, tap on the center bolt to dislodge the crank.

    Bookmark   September 12, 2007 at 9:04AM
Thank you for reporting this comment. Undo
akachrisinmass

?pardon

    Bookmark   September 15, 2007 at 6:39AM
Sign Up to comment
More Discussions
Ice in garage on mild winter days
We have a two story house with an attached 2 car garage....
boubou64
Shop vacuum
Are there any good 12 -15 amp shop vacs that have 1200-1500...
randalls1
garage door remote opens but wont shut door
I have a 10 year old Craftsman garage door opener model...
Junky
Garage Door Exterior Lighting Help Please
Hello members, On the exterior, do you prefer lighting...
pippit
Need help diagnosing Chamberlain Garage Door Problem
Hi, Have a 1/3 Chamberlain Liftmaster that started...
koalb01
© 2015 Houzz Inc. Houzz® The new way to design your home™