Stanley garage door opener problem

mcg1September 26, 2013

My stanley garage door opener only closes when I press and hold the wall switch for the opener until it closes. If you release before it closes it will stop closing and flash the light on the opener. It opens fine with the remote or the wall switch.

Thank you for reporting this comment. Undo
mike_kaiser_gw

I think it's been a long time since Stanley made a GDO. Off hand, I'd suspect the sensors. Could have failed, bad connector, or out of alignment.

    Bookmark   September 27, 2013 at 9:05PM
Sign Up to comment
More Discussions
Light on my garage door opener won't turn off
The light on my old Genie Medallion Series garage door...
liviey
Mountain of leaves on my driveway
So I acquired a huge pile of leaves that I used for...
bibbus
Shop vacuum
Are there any good 12 -15 amp shop vacs that have 1200-1500...
randalls1
What's the Lowdown on Garage Door Brands??
I have read some prior posts on steel garage door brands...
Xena99
Need error codes for Craftsman 41A4315-7D.
Need error codes for Craftsman 41A4315-7D Garage Door...
don831
© 2015 Houzz Inc. Houzz® The new way to design your home™