Need Help On Garage Lights

ducheja2July 12, 2013

I recently installed new garage lights, the old lights were dusk to dawn with sensor on the outside wall in the brick area. The new lights take a 60 -100 watt bulbs, but I am not sure if they are compatible to the old wall sensor. I first tried a 75 watt no light now I have a 60 watt incandescent still no light. Do I or can I put a screw in bulb sensor on each light or is there a bigger problem?

Thank you for reporting this comment. Undo
tim45z10

I have put black electrical tape over the sensor with success.

    Bookmark   July 19, 2013 at 7:28PM
Sign Up to comment
More Discussions
Keyless lock for manual garage door?
I have a two car garage with separate manual lift garage...
mrpandy
Need error codes for Craftsman 41A4315-7D.
Need error codes for Craftsman 41A4315-7D Garage Door...
don831
Craftsman Garage Opener Clicks only and LED blinking 5 times
My 1/2 HP Model 139.53641SRT opener clicks to all my...
nosleep
Good material to patch potholes in old garage floor?
I have some pot holes in my 1963 garage floor. The...
griz8312
Need Help with My SnowBlower
I just recently bought a Craftsman 24" snow thrower,...
bdouble
Sponsored Products
Antique Tiffany Bedroom Table Lamps Lighting Fixture
ParrotUncle
Deep Lichen Green - Satin Light Gray Shade Ovo Table Lamp
Lamps Plus
Medium-Density Optimum Radiance Gold Mattress Set
$1,199.99 | zulily
Kichler Sarabella Traditional Chandelier
1800Lighting
Artemisa Linen Drapery Fabric in Dusty Rose
$20.00 | FabricSeen
Daylight Professional LED Neck Magnifier - UN91221
$39.99 | Hayneedle
PH 3/2.5 Outdoor Light Post by Louis Poulsen
$1,196.00 | Lumens
Valiant Violet Bold Stripe Apothecary Table Lamp
Lamps Plus
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™