Genie Garage Door Opener problem

areddyMay 28, 2007

I have a set of Genie Screw Drive Garage door openers in my garage. One of them does not start, it makes a small clicking noise. Only when I disengage and engage the drive once can I open the garage door. Closing the door is never a problem. I am not sure why this is. Any ideas/hints appreciated.

- Ash

Thank you for reporting this comment. Undo
jwetzel

There should be two small adjusting knobs on the opener that will increase or decrease the amount of opening / closing force the opener will exert. Try turning up the opening force knob a little until it will open. I would also apply some grease (check owners manual) to the screw as it may be getting dry...hence the opening issues.

    Bookmark   June 26, 2007 at 11:37PM
Sign Up to comment
More Discussions
Good material to patch potholes in old garage floor?
I have some pot holes in my 1963 garage floor. The...
griz8312
Cabinets
Hi friends, I am looking for cabinets for my garage...
davidnc
Wayne Dalton i-Drive vs. Belt Drive vs. Screw Drive
Hello All, I am looking to install 2 new garage door...
rogeroh
Sears GDO does not close
I've searched on the forum without any luck. My Sears...
jerseybob_gw
Shop vacuum
Are there any good 12 -15 amp shop vacs that have 1200-1500...
randalls1
Sponsored Products
Fanmats Collegiate 27 in. Baseball Mat - 2672
$32.99 | Hayneedle
Genie ChainLift Extension Kit - 37648R
$29.99 | Hayneedle
ClosetMaid SuiteSymphony Tie and Belt Rack - 8950
$39.99 | Hayneedle
Old Havana Floor Fan by Fanimation Fans
$1,496.75 | Lumens
EON Resin Outdoor Conversation Set - GLC015
Hayneedle
ClosetMaid 5-8 ft. Closet Organizer - 1628
$67.99 | Hayneedle
22'' Narrow Oval Blades by Fanimation Fans
$299.00 | Lumens
PlayStar Playsets Climbing Wall - PS 8850
$293.99 | Hayneedle
People viewed this after searching for:
© 2015 Houzz Inc. Houzz® The new way to design your home™